I did the 110 mile ride today in unfamiliar territory and ended up turning off the Zumo after 5 miles as it was a safety distraction and simply shot from the hip. I have about 10 of them and half way through writing this, I tried the otherones as well but except for the Zumo's, they all need basecamp. Bottom line, although plotaroute is much better at plotting a route than other programs (wonderful considering some alternatives), it is absolutlly useless for my Garmins. this creates issues as the gps is trying to put that vector on to the road flow so when the vehicle actually comes to an intersection, it starts calling out turns and U Turns to put you on track but the vector maintains itself to the next turn point. when you use either of them, they simply show up on the gps screen as a vector (straight line between the two points, not following the actual flow of the road). When it reloads, it tells you that there are new files to import, select route, select the files and then import and they import successfully. same error as shown in my original thread.īoth Route and Track will go into the Zumo's. You simply connect those units to the computer and drag over the files into the gpx folder. No saved version (route or track) will load into basecamp for use with the 3590. The 3590 which requires basecamp and a Zumo 660 and a Zumo 665 (motorcycle GPS units) that do not require basecamp. I am trying to use two (three actually) differnt types of Garman GPS units. Start near 403-439 Main St, Virginville, PA 19564, USA If you need more input, let me know as I will be happy to help you, help me get this fixed. Version 4.6.2 2008-2016. The systems I am using are Windows 10 and Windows 7, all current with updates. I cleaned out all the leftover files/folders prior to installing the new version to ensure a clean install. This is the header info in the file including a couple of start points to see if it helps anyone to determine the issue. Also, I deleted basecamp and downloaded the most current version. This seems to be an old issue however, as a new user, I have saved several files as gpx routes however, when I try to import them into basecamp (import into my collection), each file errors out with the following: Unknown error. If you need them I can make the routes and tracks (and the BaseCamp versions) public, so you can play with them. I subsequently tried it with my Edge 510 and the same thing happened - I was able to get around this by using a PC to manually delete all locations (this was a TCX track and the turn instructions were still there). In the past, when I used ViewRanger to post a 50-mile circular route, someone wrote back that their attempt to import it to their Garmin device resulted in their memory being filled with a vast number locations - they were not best pleased. The only thing I did notice (and I've seen this using ViewRanger as well) was that a large number of "locations" were now listed in BaseCamp and on my Garmin if I manually added the routes/tracks. Once imported the tracks could be converted into Garmin routes without problems. The routes didn't work at all (but they did successfully import manually into my Garmin) but both of the tracks did. both routes and tracks with and without turn-by-turn directions) and then tried importing them into BaseCamp. To test out the reported problem I used your site to create a 20-mile "work to home" route. I'm new to PlotaRoute so forgive me if my comments are rubbish.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |